開始
erase ^?, werase ^W, kill ^U, intr ^C, status ^T
(I)nstall, (U)pgrade or (S)hell? i〈Enter〉
Terminal type? [vt220] 〈Enter〉
kbd(8) mapping? ('L' for list) [none] jp〈Enter〉
kbd: keyboard mapping set to jp
Proceed with install? [no] y〈Enter〉
Cool! Let's get to it...
ディスク環境の設定
Available disks are: wd0.
Which one is the root disk? (or 'done') [ed0] 〈Enter〉
Do you want to use *all* of wd0 for OpenBSD? [no] y〈Enter〉
| ラベル |
ディレクトリ |
サイズ |
| a: |
/ |
8GB |
| b: |
swap |
2GB |
|
Initial label editor (enter '?' for help at any prompt)
> _
Initial label editor (enter '?' for help at any prompt)
Available commands:
? [cmnd] - this message or command specific help.
a [part] - add new partition.
b - set OpenBSD disk boundaries.
c [part] - change partition size.
D - set label to default.
d [part] - delete partition.
e - edit drive parameters.
g [b|d|u] - Use [b]ios, [d]isk or [u]ser geometry.
M - show entire OpenBSD man page for disklabel.
m [part] - modify existing partition.
n [part] - set the mount point for a partition.
p [unit] - print label.
q - quit and save changes.
r - recalculate free space.
s [path] - save label to file.
u - undo last change.
w - write label to disk.
X - toggle expert mode.
x - exit without saving changes.
z - zero out partition table.
Numeric parameters may use suffixes to indicate units:
'b' for bytes, 'c' for cylinders, 'k' for kilobytes, 'm' for megabytes,
'g' for gigabytes or no suffix for sectors (usually 512 bytes).
'%' for percent of total disk size, '&' for percent of free space.
Non-sector units will be rounded to the nearest cylinder.
Entering '?' at most prompts will give you (simple) context sensitive help.
> _
